Williams Flash (Williams, 1978) drop target bank Left side

[faralos]

found a broken wire hanging down which is probably
the reason the entire bank ain't scoring or resetting
but before I go and solder it onto anything
does anyone know exactly what it is supposed to go onto?
there is a lead that has solder on it but I am trying to get another opinion
before I touch anything to each other possibly frying the entire drop target set
I am hoping that the arrow I show is the proper place for the wire to go
but can anyone help just to make sure?

 

[Coil_Smoke]

Expired Film...???

Hey Faralos, Every wire in these photos looks orange&white(Ish). It's an orange and white photo to. You got your self some nice antiqu-y looking pictures but not much help in identifying what's what. Knowing the actual wire and trace colors might help. Do any of the drop targets score when they drop? let's have a look at the schematics and see what we can figure out...C_S

 

[pinballdaveh]

when i check the switch matrix chart column 5 grn-blk wire i see that it goes to the 5 drop target bank stand up switch behind the rubber. from there it feeds 4 of the 5 drop targets and 5 bank series. so yes the wire that came off gets soldered on to the grn-blk wires of the 5 bank stand up switch.

 

[faralos]

it is an orange jumper wire that is hanging all the rest there are yellow ones
and the blue black ones are where that soldered lead is!
thanks for the advice pinballdaveh!
I was hoping that was where it was to go not seeing anywhere else it could have gone

 

[faralos]

my camera tends to go into that yellowed lighting mode when taking close up and not using a flash sorry for that!!

 

[Coil_Smoke]

Well, it gave your post a nice old-timey feel.