Reply to thread

Message

Fixes added so far:

' - added ball saver to the start of each mode
' - added Tilt Warning Recovery control option
' - added DF1 to upper right flippers, adjusted angle slightly (mid-right flipper makes it much easier to hit to Mania Modes when cradled)
' - if Mania Modes was lit when starting multi-ball, it will now be lit again after multi-ball ends
' - changed kicker brake plates to not be set to "Mark as Ornamental"
' - fix for upper flippers not turning off for tilt
' - fix goal post not rotating correctly on drain (should show Robotnik)

...and I'm currently adding in updated PinEvent V2 control code.

Adding in the new spinner code brings back the original problem that I fixed in the table's xml, which was to stop the spinner from bobbing back and forth non stop after its been hit. It should come to a stop. Without the new code it does come to a stop, but occasionally stops horizontally. I need to find a way to have that not happen at a minimum.

<blockquote data-quote="TerryRed" data-source="post: 135553" data-attributes="member: 27808">Fixes added so far:&#039;&nbsp; &nbsp; - added ball saver to the start of each mode&#039;&nbsp; &nbsp; - added Tilt Warning Recovery control option&#039;&nbsp; &nbsp; - added DF1 to upper right flippers, adjusted angle slightly (mid-right flipper makes it much easier to hit to Mania Modes when cradled)&#039;&nbsp; &nbsp; - if Mania Modes was lit when starting multi-ball, it will now be lit again after multi-ball ends&#039;&nbsp; &nbsp; - changed kicker brake plates to not be set to &quot;Mark as Ornamental&quot;&#039;&nbsp; &nbsp; - fix for upper flippers not turning off for tilt&#039;&nbsp; &nbsp; - fix goal post not rotating correctly on drain (should show Robotnik)...and I&#039;m currently adding in updated PinEvent V2 control code.Adding in the new spinner code brings back the original problem that I fixed in the table&#039;s xml, which was to stop the spinner from bobbing back and forth non stop after its been hit. It should come to a stop. Without the new code it does come to a stop, but occasionally stops horizontally. I need to find a way to have that not happen at a minimum.</blockquote>

[QUOTE="TerryRed, post: 135553, member: 27808"] Fixes added so far: ' - added ball saver to the start of each mode ' - added Tilt Warning Recovery control option ' - added DF1 to upper right flippers, adjusted angle slightly (mid-right flipper makes it much easier to hit to Mania Modes when cradled) ' - if Mania Modes was lit when starting multi-ball, it will now be lit again after multi-ball ends ' - changed kicker brake plates to not be set to "Mark as Ornamental" ' - fix for upper flippers not turning off for tilt ' - fix goal post not rotating correctly on drain (should show Robotnik) ...and I'm currently adding in updated PinEvent V2 control code. Adding in the new spinner code brings back the original problem that I fixed in the table's xml, which was to stop the spinner from bobbing back and forth non stop after its been hit. It should come to a stop. Without the new code it does come to a stop, but occasionally stops horizontally. I need to find a way to have that not happen at a minimum. [/QUOTE]

Verification

Reply to thread

Settings Notifications

Options